Let's get started!
Disclaimer:
Due to the wide variety of devices available and potential variations in their firmware, the information presented below may or may not be accurate. For this same reason, OpenDNS support will generally not be able to provide device-specific assistance beyond what is provided below. If you need further assistance specific to your device, please contact either the manufacturer's support team, or your ISP if you are using leased equipment.
Note:
The manual for the Cisco Valet device can be downloaded from http://downloads.linksys.com/downloads/userguide/1224655305646/Valet_Valet_Plus_M10_M20_UG_US_V10_D-WEB_3425-01453,0.pdf
- Log into your Cisco device by typing the IP address in your browser's address bar 192.168.1.1, log in with the username: admin and password: admin (page 14)
- Click the SETUP tab and BASIC SETUP, then scroll down to the STATIC DNS fields.
- Enter these IP addresses in the three Static DNS fields:
- 208.67.222.222
- 208.67.220.220
- 208.67.222.220
- Save your settings and the device will reboot.
Okay, what's next?
To ensure that OpenDNS is working properly for you, please flush your browser and DNS cache by using the steps below:
http://www.opendns.com/support/article/67
http://www.opendns.com/support/article/68
Visit http://welcome.opendns.com and you will be greeted with a welcome message, letting you know that you're fully configured.
Note:
If you experience any difficulties with this setup, feel free to send us a help desk ticket at http://support.opendns.com. To help us look into your issue quicker, download the diagnostic tool below, run it, then copy the results URL to this message.
Mac http://www.opendns.com/download/mac/diagnostic
Windows http://www.opendns.com/download/windows/diagnostic