I can no longer access my Bell Quick Setup

rcorneau

July 05, 2014 15:14

I use to be able to access my primary bell set up at http://192.168.2.1/ but I can no longer do so after configuring OpenDNS. What can I do?

0

Comments

5 comments

rotblitz July 05, 2014 16:49

How exactly dos this look like, this unability to access http://192.168.2.1/ ?

In case you have a Windows computer, post the complete plain text output of the following command here:

ipconfig /all

0

Comment actions Permalink
rcorneau July 06, 2014 15:39

I'm on a Mac...normally I would just go to 192.168.2.1 to access my modem's configuration...passwords, wireless devices, etc...but since I have OpenDNS running, I can no longer access this site. It's just says this web page is not available.

0

Comment actions Permalink
rotblitz July 06, 2014 22:16

You may have done it wrong with configuring the OpenDNS resolver addresses. So, back out what you did, and it should work again.

Then point me to an online user manual of your device, and I will look how this can be configured. If there's no manual, post a screen shot of the page where your configured OpenDNS.

0

Comment actions Permalink
rcorneau July 07, 2014 04:07

Ok, so I reset my router and deleted whatever I've done on OpenDNS. Here are some screen shots of my bell set up. Do I change the IP address in my router then in OpenDNS?

Thanks for all your help!

Screen Shot 2014-07-06 at 11.57.08 PM.png
Screen Shot 2014-07-06 at 11.55.59 PM.png

0

Comment actions Permalink
rotblitz July 07, 2014 06:13

Yes, the first screen shot looks like the right place to configure the OpenDNS resolver addresses, only there. Don't change anything else on your router.

0

Comment actions Permalink

Please sign in to leave a comment.